Delidigi Google WiFi Wall Mount ABS Bracket Holder Shelf for Google Nest WiFi Router [Built-in Cable Management] (White)

Got this to wall mount a couple of Nest WiFi's. Looks - It looks exactly as pictured. It is not necessarily the most elegant looking thing, but it is clean looking and suitable for most places. If you look at the pics, you will see around the bottom side there is a gap, that is where the cord wraps around. It would look a bit more elegant if it did not have that gap, but for me it was fine. One thing, the two mounting screws are black, whereas it would have looked better if they were white. You can always paint the heads or put whiteout on them if this bothers you. Installation - They provided the screws and anchors (if you need them). I was able to install by just screwing them in. I used a level after the first one was in and had no trouble getting this mounted on the wall nicely. Cord management - It is not obvious from the pics, but the cord gets wrapped around the gap by the bottom. To get the best results I unplugged from the outlet, plugged the Nest Wifi in, and then wrapped and finally pulled the cord back to the outlet. This let me get the tightest fit I can. There was for both points some extra wire, so that is kind of sitting there behind the unit and is not noticeable. All-in-all, a suitable solution. Fit - The Nest Wifi fits into it perfectly. Other than that, not much to say. Does what I needed, looks fine (especially after putting some white-out on the screw heads), and seems sturdy. Would recommend for anyone looking for a wall mount for the Nest Wifi.

The master bedroom in my brick ranch house was added on after the original house was built, and all four walls are solid brick! The wall connecting the room to the original house is nearly a foot thick with the original brick exterior wall covered on both sides by studs and drywall. It's very difficult to get a decent wifi signal through that wall. After I tested the signal with a wifi analyzer app on my Android phone, I found that to get a stong enough wifi signal to get acceptable performance, I needed to place my Nest point right in the middle of the doorway, which was the only place I could get a direct shot to the router without going through a brick wall. I don't know how well it would have worked through a solid wood door, but fortunately my bedroom door is white plastic. The signal penetrated quite well, and I was able to use one of these Delidigi wall mounts to hold the Nest point in the location providing me with the strongest signal from the router. I mounted it to the door (white bracket on white door supporting a white Nest point; looks nice!). I also bought a small $4 package of Command 17026CLR-ES Decorating Clips, Clear, 20-Clips that neatly routed the cable along the door, down the door, and over to the wall, so the door opens and closes fully without disturbing the access point. It really looks fine and professional. I wouldn't hesitate to buy one of these wall mounts. They look and work great.

Very simple and easy to install.

This wall mount worked great

Really good wall mount. I placed mind in the kitchen and installed it on a cabinet so I can get a solid signal in that area of my house. Pretty easy to install and I like that it has a chord keeper under the plate. You can wind up the excess power chord around the circle underneath the wifi holder. Pretty handy. Does a great job and looks nice too.